Sequoia Series 211
WHMeter:ETIMe?
This command will return the total amount of time the watt-hour meter has accumulated. The returned
data has four fields separated by commas. These fields are hours, minutes, seconds and milliseconds.
Command Syntax WHMeter:ETIMe?
Parameters none
Query Syntax WHM:ETIM?
Returned Parameters h,mm,ss,ms
WHMeter:WHOur?
Phase Selectable
This command will return the total accumulated kilowatt-hours for the selected phase. If coupling is set
to "all", the value returned is the sum of all phases in the system regardless of the selected phase.
Command Syntax WHMeter:WHOur?
Parameters none
Query Syntax WHM:WHO?
Returned Parameters <numeric value>
Note: If the watt-hour meter is active, the total power of all phases in the system will
be returned when querying the power.
To Next Page
Loading...
