72 Sequoia Series
OUTPut:TTLTrg:SOURce
This command selects the signal source for the Trig Out signal as follows:
• BOT Beginning of transient output
• EOT End of transient output
• LIST Specified by the TTLTrg list
When an event becomes true at the selected TTLTrg source, a pulse is sent to the function strobe on
the system interface connector on the rear panel of the power source.
Command Syntax OUTPut:TTLTrg:SOURce<source>
Parameters BOT|EOT|LIST
*RST Value BOT
Examples OUTP:TTLT:SOUR LIST
Query Syntax OUTPut:TTLTrg:SOURce?
Returned Parameters <CRD>
Related Commands OUTP:TTLT
To Next Page
Loading...
