Sequoia Series 89
LIMit:PHASe
This command will configure the power source controller for the number of output phases. A value of
zero will configure the source as a single-phase unit. A value of 120° will configure the power source
controller as a three phase unit with a 120° phase offset between phase A, B and C. Any other value
will configure the controller as a two phase unit using phase A and C.
Command Syntax [SOURce:]LIMit:PHASe<NRf>
Parameters 0 to 360 [command protected]
Query Syntax [SOURce:]LIMit:PHASe?
Returned Parameters <NR2>
To Next Page
Loading...
