Ametek SEQUOIA Series - Page 9

Sequoia Series 9
Table of Figures
Figure 2-1 : Partial Command Tree ..................................................................................................................... 15
Figure 2-2: Command Message Structure ........................................................................................................... 18
Figure 3-1: DB25 to DB9 Adaptor pinout ............................................................................................................. 25
Figure 3-2: GUI Interface Settings for use of USB port. ....................................................................................... 29
Figure 3-3: Pinging AC Source LAN IP address. ................................................................................................. 31
Figure 6-1: Output transient system .................................................................................................................. 162
Figure 6-2: Transient Trigger System Model ..................................................................................................... 166
Figure 6-3: Measurement Acquisition Trigger Model ......................................................................................... 173
Figure 6-4: Pre-event and Post-event Triggering............................................................................................... 176
Figure 6-5: Trigger system block diagram ......................................................................................................... 177
Figure 7-1: Status System Model ...................................................................................................................... 179
Table of Tables
Table 3-1. RS-232C Interface Connector Pinout ................................................................................................. 23
Table 4-1 : PULSe:HOLD = WIDTh parameters ............................................................................................... 112
Table 4-2 : PULSe:HOLD = DCYCle parameters .............................................................................................. 112
Table 5-1 : *RST default parameter values ....................................................................................................... 149
Table 5-2 : Self-Test Error ................................................................................................................................. 152
Table 7-1: Operation Status Register ................................................................................................................ 178
Table 7-2: Configuration of Status Register ....................................................................................................... 180
Table 7-3: Questionable Status Register ........................................................................................................... 181
Table 8-1 : Error Messages ............................................................................................................................... 223