Firmware Pages and Descriptions
102
10" Modero Touch Panels
Refer to the Using G4 Web Control® to Interact with a G4 Panel section on page 72 for more detailed
instructions on how to use the G4 Web Control page with the new web-based NetLinx Security application.
Sensor Setup
The Sensor Setup page (FIG. 99) allows you to adjust the Light and Motion Sensor parameters on a Modero
touch panel.
G4 Web Control Page Elements (Cont.)
Web Control Password Allows you to enter the G4 Authentication session password associated for
VNC web access of this panel.
Web Control Port Allows you to enter the port value that the VNC Web Server runs on.
• Default value is 5900.
Maximum Number of
Connections
This read-only field displays the maximum number of users that can be
simultaneously connected to the target panel via the web.
• Default value is 1.
Current Connection Count This read-only field displays the current number of users connected to the
target panel via the web. This value cannot exceed the Maximum number field.
G4 Web Control Timeout: Sets the length of time (in minutes) the panel can remain idle (no cursor
movements) before the session is closed and the user is disconnected.
• Minimum value = 0 minutes (panel never times-out)
• Maximum value = 240 minutes (panel times-out after 240 minutes/4hours)
FIG. 98
Sample relationship between G4 Web Control and Mange WebControl Connections window
FIG. 99 Sensor Setup page
A light level value between the Minimum and Maximum DIM Mode values delivers an
average light level. The DIM mode Min Level can never exceed the DIM Mode Max
Level.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
