11
COMBIFIT installation, use and maintenance manual
GB
Secure the cable with the cable gland.
relation to the rated voltage by more than ± 10%.
the standards in force. For the connection use the clamp,
placed on the frame and marked with the symbol ,
to which you should connect a cable with the minimum
section of 10 mm².
Before putting the oven into operation, you should carefully carry out
all the necessary checks to ascertain the conformity of the equipment
and installation of the appliance as provided by law and according to the
technical and safety instructions given in this manual.
You should also check that the compliance of the following:
should be greater than +4 ° C.
All packages must have been completely removed, including the
should be reinstalled.
upstream of the unit must be opened.
Oven should be tested by completing a cooking cycle to verify that the
equipment works properly, without any anomalies or problems.
(next page)
Set a cooking cycle with temperature to 150 ° C, time set to 10 min.
and humidity to 25%.
Press the key () “Start/Stop”.
Carefully check the points given in the following list:
By pressing the power button (), the lights in the cooking
chamber light up and after 45 seconds, if not turned off before pressing
the button again, will turn off automatically.
To Next Page
Loading...
Need help?
General