17
COMBIFIT installation, use and maintenance manual
GB
select it by pressing the display . Set the time turning the dial
clockwise to increase the time or counterclockwise to decrease it.
the key again or by pressing
the dial M of the encoder.
innite position can be
found by turning the dial M
counterclockwise.
from the moment in which you
press the key “Start” (
) and, however, after the
completion of the automatic pre-
heating cycle.
a minor alarm.
In case of major alarm, however, the cooking cycle is permanently
interrupted and once you have solved the problem that caused the
alarm, it cannot be resumed. In this case, you should set a new cooking
cycle.
When the time set elapses, the oven stops automatically in “stand-by”
condition and generates an audio signal that lasts about 15 seconds.
In or cooking mode, select the fan speed setup
page on display () and choose the desired speed turning the
dial clockwise to increase the value or counterclockwise to decrease it.
or the display .
-
tures/feature 6 rotational speeds
that can be set by the user.
Dom 02-10-15 20:32
180°
1:20
PRE
HEAT
Manuale
Fase 1 / 4
Dom 02-10-15 20:32
180°
1:20
PRE
HEAT
Manuale
Fase 1 / 4
To Next Page
Loading...
Need help?
General