Instrument Notifications and Troubleshooting A-4 Informational Notifications
MS2090A UG PN: 10580-00444 Rev. U A-9
Measurement changed. Trace playback stopped
In Toolbar, Logged, Transient
Measurement changed. Trace recording in csv stopped
In Toolbar, Logged, Transient
Memory Full
Popup, Not Logged, Transient
Memory Full
In Toolbar, Not Logged, Transient
Model and/or serial number of the device does not match calibration stored. 1-Port ReadyCal will be applied
In Toolbar, Not Logged, Transient
Missing GPS data. Ensure good GPS fix or directional antenna connection
In Toolbar, Not Logged, Persistent
New calibration type is not supported by <cal method>.Switching cal method to <cal method name>
In Toolbar, Not Logged, Transient
No bearing from directional antenna. Check connection and try again
In Toolbar, Not Logged, Transient
No USB CAA HW connected
In Toolbar, Not Logged, Persistent. The user calibration may be turned off if CAA hardware is not
connected.
No USB Site Master is detected. Please connect device to continue.
In Toolbar, Not Logged, Transient
No application loaded. Factory reset required
In Toolbar, Logged, Persistent
<Model> Sensor connected
In Toolbar, Logged, Persistent
Outdoor mapping requires GNSS/GPS
In Toolbar, Not Logged, Persistent
Options upgraded. Please restart the instrument to use new features
In Toolbar, Not Logged, Transient
Preset Completed
In Toolbar, Not Logged, Transient
To Next Page
Loading...
