5.4 Device Message
5-15
*RST (Reset Command)
Function
Initializes the MP8931A at level 3.
Header Program command Query Response
*RST *RST --- ---
Example use
*RST
Description
(1) Initializes targeted device parameters.
(2) Puts the device into OCIS (Operation Complete Command Idle State.)
(3) Puts the device into OQIS (Operation Complete Query Idle State.)
The following items are not affected by this command:
(1) GPIB interface status
(2) GPIB address
(3) RS-232C interface status
(4) Output queue
(5) Service request enable register
(6) Standard event status enable register
*SRE (Service Request Enable Command/Query)
Function
Enables the specified bit of service request enable register.
Header Program command Query Response
*SRE *SRE n *SRE? n
Value of n
0 to 255
Example use
*SRE 1
*SRE?
Example response message
1
To Next Page
Loading...
