1.2.2. ENVIRONMENTAL CONDITIONS
The equipment is to be installed in rooms that satisfy the following requirements:
• temperature between 10 and 40°C;
• relative humidity between 30 and 75%;
• atmospheric pressure ranging from 700 to 1060 hPa;
• altitude ≤ 3000 m;
• air pressure entering equipment ranging from 6 to 8 bar;
• water hardness at the equipment inlet must not be above 25 °f (French degrees) or 14 °d (German degrees) for untreated drinking water. For water
with a higher hardness degree, it is recommended to soften water until it reaches a hardness degree between 15 and 25 °f (French degrees) or
between 8.4 and 14 °d (German degrees);
• water pressure entering equipment ranging from 3 to 5 bar;
• water temperature entering equipment not higher than 25°C.
• water conductivity at 20°C: < 2000 μS/cm.
• recommended water acidity: 6.5-8.5 pH (ISO 7494-2-2015);
• the electric system in the room in which the equipment is installed must conform to IEC 60364-7-710 (standards for electric systems in medical and
dental offices).
• floor condition: continuous type with a dowel breaking strength of not less than 260 daN each (installation with the aid of the load distribution plate) or
1200 daN each (installation without the aid of the load distribution plate).
1.2.2.1. STORAGE CONDITIONS
• Temperature between -10 and 70°C;
• Relative humidity between 10 and 90%;
• Atmospheric pressure: from 500 to 1060hPa.
1.2.3. WARRANTY
CEFLA s.c. stands behind its products warranting safety, reliability and performance.
The warranty is effective from the date of installation of the product.
The product is covered for the warranty period indicated in the Installation Report and, in any case, not less than 12 months.
The warranty is valid only under the following terms:
• Conditions given on the warranty certificate are observed.
• Yearly scheduled maintenance is performed.
• The equipment is used only as instructed in this manual.
• The equipment must be installed in an environment that complies with the requirements of the ENVIRONMENTAL CONDITIONS section.
• A 3x1.5 mm
2
line protected by a bi-polar cut-out that conforms to applicable standards (10 A 250 V or 15 A 120 V distance between contacts at least 3
mm) must be used to feed the equipment.
• Installation, repairs, equipment enlargement, settings and, in general, any other operation requiring the casing to be opened are to be performed
exclusively by personnel authorised by CEFLA s.c..
1.2.4. DISPOSING THE EQUIPMENT WHEN NO LONGER USED
In compliance with Directives 2011/65/EU and 2012/19/EU regarding restriction of the use of certain hazardous substances in electrical and electronic
equipment along with waste electrical and electronic equipment, it is forbidden to dispose of this equipment in the municipal waste stream as unsorted
municipal waste.
When purchasing a new device of an equivalent type, one for one, the device that has come to the end of its lifetime should be returned to the dealer for
disposal. As regards reuse, recycling and other forms of recovery of waste electrical and electronic equipment, the Manufacturer carries out the
functions defined by current local laws. Appropriate differentiated waste collection for subsequent recycling treatment and environmentally friendly
disposal contributes to preventing possible negative effects on the environment and health and encourages recycling of the materials of which the
device is made up. The symbol indicating separate collection for electrical and electronic equipment consists of the crossed out bin marked on the
equipment.
To Next Page
Loading...
