Arkray ADAMS A1C HA-8180V - Chapter 1: HA-8180 V Part Identification; 1.3.1 Front and Right Side Views of HA-8180 V; 1.3.2 Rear View of HA-8180 V

HA-8180V x
4.2.5 Replacing the Piercing Nozzle/Cleaning the Nozzle Washing Block . 4-15
4.2.6 Replacing the Mesh Filters of the Reagent Nozzles .......................... 4-21
4.2.7 Replacing the Tubes of the Drain Pinch Valves................................. 4-24
4.3 Washing and Cleaning ....................................................................4-26
4.3.1 Discarding Liquid Waste .................................................................... 4-26
4.3.2 Automatically Washing the Tubes...................................................... 4-26
4.3.3 Automatically Washing the Tubes After Measurement ...................... 4-28
4.3.4 Cleaning the Piercing Nozzle............................................................. 4-30
4.3.5 Cleaning the Sample Tube Spinning Unit .......................................... 4-32
4.3.6 Cleaning the Dilution Container and Washing Container................... 4-34
4.3.7 Cleaning the Parts of the Dilution and Washing Containers .............. 4-37
4.3.8 Disinfection ........................................................................................ 4-40
4.4 Priming..............................................................................................4-41
4.5 Recording Maintenance ..................................................................4-42
4.5.1 Recording the Date of Maintenance .................................................. 4-42
4.5.2 Viewing Maintenance History............................................................. 4-43
4.6 Before/After Extended Periods of Disuse......................................4-44
4.6.1 Preparing the Instrument Before Extended Periods of Disuse .......... 4-44
4.6.2 Starting Up the Instrument After Extended Periods of Disuse ........... 4-51
Chapter 5 Troubleshooting ....................................................... 5-1
5.1 If a Warning Occurs ...........................................................................5-2
5.1.1 From Warning Occurrence to Remedy ................................................ 5-2
5.1.2 Causes and Remedies......................................................................... 5-3
5.2 If an Error Occurs ..............................................................................5-9
5.2.1 From Error Occurrence to Remedy...................................................... 5-9
5.2.2 Causes and Remedies....................................................................... 5-10
5.3 If Trouble Occurs .............................................................................5-12
5.3.1 From Trouble Occurrence to Remedy ............................................... 5-12
5.3.2 Causes and Remedies....................................................................... 5-13
5.4 Abnormal Result Messages ............................................................5-20
5.5 If This Happens ................................................................................5-22
5.5.1 If the Instrument Does Not Start Up (Replacing Fuses)..................... 5-22
5.5.2 Replacing the Column Tubes............................................................. 5-24
5.5.3 If Eluent Packs Are Incorrectly Attached............................................ 5-27
Chapter 6 Appendix ................................................................... 6-1
6.1 Printed Report Examples ..................................................................6-2
6.1.1 Current Parameter Settings ................................................................. 6-2
6.1.2 Accuracy Control Reports .................................................................... 6-4
6.1.3 Optical Unit Monitoring Results............................................................ 6-5