HA-8180V 2-22
Chapter 2 Measurement
2.5.2 Measuring Samples
Once samples have been prepared, start measurements.
1 Set the measurement start number (if needed).
On the standby screen, check the measurement start number. Set a different number if necessary. If you do not change
the number, skip to step 2.
a On the standby screen, press .
b Below <Normal measurement samples>, enter a new
measurement start number.
• Range: 0000 to 9999
c Press .
• This saves your entry and will return you to the standby screen.
• The entered number will appear in <Measurement start number>
on the standby screen.
2 Start measurement.
a On the standby screen, check the [Measurement mode] setting.
• To change the mode, see “2.4. Measurement Mode Selection (Variant or Fast)” on page 2-14.
Ready for measurement
10-06-2010 10:00
Measurement start number 0001
Measurement : Variant
Column 0000
ABCH
Menu Meas No. Priming Cal
Meas No.
Measurement start number
10-06-2010 10:00
Normal measurement samples
<0300>
HbA1c control
<0001>
PrevItem BS OK Cancel
This instrument stirs samples before measuring them. Due to a possible risk of injury, do not touch the
spinning unit or sample container, or insert anything in-between the STAT port cover and front cover while the
sample tube is spinning. Also, check that the STAT port cover is attached correctly before starting
measurement.
To Next Page
Loading...
Need help?
General
