Measurement number setup
Measurement start number
[
Continue from previous batch 1
]
Meas No.
[
Assign to samples
]
========================
HbA1c measurement setup
Control expected values (mmol/mol)
L
< 0>
H
< 0>
Control measurement count
[3]
Control error range (mmol/mol)
L
< 3>
H
< 4>
Operation if control error occurs
[
Stop measurement
]
Pressure unit
[kg/cm2]
STD. solution measurement count
[3]
Calibration error range (%)
<3.0>
Column degradation
[
Use
]
Misread barcodes
< 0>
Sample tube spin failures
< 0>
========================
Measurement mode setup
Measurement mode
[
Variant
]
========================
Printer setup
Use/Not use
[
Use
]
Peak information
[
Print
]
Chromatogram
[
Print
]
Data list
[
Print
]
Reagent information
[
Not Print
]
========================
External output setup
Use/Not use
[
Not use
]
========================
Beeper volume setting
Beeper volume
[5]
Number of sample tube spin failures at which measurement
stops
Measurement mode: Variant/Fast
Number of misread barcode errors at which measurement
stops
Printer: Use/Not use
Peak information:
Included/Not included in measurement result reports
Data list:
Printed automatically after each batch/Not printed
automatically
Reagent information:
Not printed/Printed on measurement result reports/
Printed at the beginning of each batch
External output: Use/Not use
Beeper volume
Chromatogram:
Included/Not included in measurement result reports
HbA1C calibration: Error detection range
Column replacement message: Use/Not use
Measurement start number setting
Measurement number setting
Control expected values
Control measurement: Error detection range
Control measurement: Action in case of error
Pressure unit of the column
HbA1C calibration:
Number of measurements per sample container
HbA1C control measurement:
Number of measurements per sample container
To Next Page
Loading...
