Menu Operation
USER MANUAL
Ascom d83 DECT Handset
2. Press and hold to open the microphone for transmitting. The microphone is muted again when
is released.
3. Multifunction button 2 may also be configured to act as the
button.
8.2.4.4 Invitation Received as Message during an Ongoing Call
If a user receives an invitation during an ongoing call, the call is disconnected and the PTT call connected if
the following conditions apply:
• The handset is configured to answer invitations automatically.
• The invitation is of higher priority than the call priority.
• The user does not reject the invitation within 10 seconds.
When the invitation is received, a warning signal notifies the user before disconnecting the current call in
order to connect the PTT call.
Depending on the priority of the invitation, the ongoing call might be disconnected immediately or
after 10 seconds.
If the user rejects the invitation, it can be re-joined later on, see 8.2.7 Re-join a Group, page 59.
8.2.5 Decline a PTT Invitation
Decline Invitation Received as Incoming Call
Press Decline, or
to reject the invitation. The handset returns to the previously shown screen. See also
8.2.7 Re-join a Group, page 59.
Decline Invitation Received as Message
Press Reject to reject the invitation. The handset returns to the previously shown screen. See also 8.2.7 Re-
join a Group, page 59.
8.2.6 Call a PTT Group
This option is only visible when PTT groups are defined. For more information, refer to the
Configuration Manual, Ascom d83 DECT Handset, TD 93426EN.
1. Press Menu.
2. Select
in the menu.
3. Select PTT groups.
4. Select PTT group.
5. Press Call, or press
.
Alternatively, when in idle mode, press PTT button or Mute button quickly, select PTT group, and
then press
.
58 TD 93434EN / 01 December 2021 / Ver. B
To Next Page
Loading...
Need help?
General
