USER MANUAL
Ascom d83 DECT Handset
Descriptions
Figure 4. Available Characters
. , ? ! - " ' 1
a b c à â æ ç 2
d e f é è ê ë 3
j k l 5
m n o ñ ô ö œ 6
t u v û 8
#
g h i î ï 4
p q r s 7
w x y z 9
Space + * 0
DEF
MNO
WXYZ
ABC
JKL
TUV
PQRS
GHI
Depending on the selected menu language, other characters are also available. This means that
the character order can differ from the figure above.
2.5.1 In Idle Mode and in Number Input Mode
• A short press on a key enters the digits 0–9 and the characters and #.
• A long press on the 0 key adds a + to the number.
• Enter a pause in number input mode by a long press on the # -key. A pause is indicated by a P in the
display.
• A long press on the
- key changes the tone sender on. Tone sender on is indicated by a T in the
display.
• The keys 0, 2–9 can be used for speed dialing. Press and hold any of the keys to access a contact
beginning with a specific letter. For example, to access a contact beginning with the letter A, press and
hold the key 2 and then press Call to speed dial.
2.5.2 In Text Input Mode
• A short press on any of the keys 0–9 displays the first available character on that specific key. The
marked character is selected after a timeout, or when another key is pressed.
• To change to upper/lower case, press the
key before entering the character. A short press on the
key can also be used to display only the digits.
• To add space in the text, short press key 0.
• The first character entered in a message or when adding/editing a name in the Contacts menu, is an
upper level character followed by lower level characters, unless the
key is pressed before entering the
character. To switch between Abc, ABC, abc, and 123, press the
key.
• A long press on the # key displays special characters.
• A long press on the
key changes the language used while entering a text.
2.6 Accessories
Additional information about all available accessories can be found at Ascom Partner Extranet.
Belt Clips
Two belt clip options are available:
TD 93434EN / 01 December 2021 / Ver. B 13
To Next Page
Loading...
Need help?
General
