Bluetooth Headset
USER MANUAL
Ascom d83 DECT Handset
Transfer a Call to the Bluetooth Headset
To transfer the call to the Bluetooth headset, press the soft key More on the handset during the call, and
select Audio transfer.
A call can also be transferred to the Bluetooth headset by pressing the button on the Bluetooth headset.
A.6 Switch to a Headset with Cord
If a headset with a cord is connected during a call, the call is not transferred to this headset
automatically. Avoid using both headset types at the same time during a call.
To change from a Bluetooth headset to a cord headset, close down the call and connect the cord headset.
A.7 Operation Notice
Accessibility and Voice quality
Bluetooth uses the frequency of 2.45 GHz. WLAN, microwave oven, and other devices that use the same
frequency can disturb the use of a Bluetooth headset.
Operation Area
Maximum distance between the headset and the handset is 10 metres. The communication distance
between the handset and headset may vary considerably due to the environment and disturbances from
other 2.45 GHz equipment. Different headsets can also give different communication distances.
Out of Range
If a connection cannot be made with the selected Bluetooth headset the call is transferred automatically to
the handset.
If the Bluetooth headset and the handset get out of range from each other the connection is temporarily lost.
Since the last connected headset is always considered "selected", the connection is automatically
established again when a call is made or received.
A.8 Environmental Requirements
Bluetooth Headset Battery
Refer to the manual for the Bluetooth headset.
A.9 Troubleshooting
Problem Reason Solution
No headset found Headset is turned off Turn on headset
Headset is out of battery Charge headset
Headset is out of range Move headset closer to handset
< 10 metre.
Headset is not in pairing mode Turn headset into pairing mode
100 TD 93434EN / 01 December 2021 / Ver. B
To Next Page
Loading...
Need help?
General
