TD 92675GB
10 January 2011/ Ver. A
Configuration Manual
Ascom i62 VoWiFi Handset
46
Example 3
This example describes the message handling with the following message settings:
• TTP= 20 seconds
• TTR= 2 minutes
Tip: It is recommended to use these settings if the user shall not be interrupted during 20
seconds while reading a message, unless a message with higher priority is received. When
the user has read a message, its priority is no longer important, that is when TTP expires. In
addition, if a message is not shown again within the TTR interval, it is considered as not
important and is removed from the queue.
Figure 6. Message handling without manually closing a message.
In figure 6, a message with prio 2 is received and displayed in the handset, TTP and TTR for
the message is started.
After 10 seconds, a second message with priority 1 is received and displayed while the
message with priority 2 is put in the queue. TTP for the message with priority 2 is paused,
but TTR continues. TTP and TTR for the message with priority 1 is started.
After 20 seconds, TTP expires but TTR continues for the message with prio 1 and the
message is placed in the queue. The message with priority 2 is shown again and its TTP
continues.
TTP expires after 10 seconds but TTR continues for the message with priority 2. In this case,
all messages have been shown 20 seconds each, and the oldest shown message with the
highest priority is displayed (in this case, the message with priority 1). The handset does
not indicate when it shows the message again, since it already has been shown and
indicated once. The message with priority 2 is placed in the queue.
After 80 seconds, the TTR expires for the message with priority 2, and it is removed from
the queue and is indicated as an unread message in the Messaging Inbox. When TTR expires
for the message with priority 1, it is also indicated as an unread message in the Messaging
Inbox.
Note: If no messages have been read/closed manually and TTP expired for each message, a
dialogue window New messages(s): [number of messages]. View now? is displayed. All
messages are indicated as unread messages in the Messaging Inbox.
Figure 4.
Prio 2
TTP expired
TTR expired
80 sec.
Prio 2
TTP expired
TTR expired
Messaging Inbox
Prio 2
New messages
Prio 2
TTP paused
TTR continues
20 sec.
Prio 1
TTP expired
TTR continues
10 sec.
Prio 2
TTP expired
TTR continues
Prio 1
New messages
Prio 2
TTP started
TTR started
Prio 1
TTP started
TTR started
Prio 2
TTP and TTR
continues
Prio 1
TTP expired
TTR continues
Prio 2
TTP expired
TTR continues
To Next Page
