ashtech DG16 - Timing Pulse and Measurement Strobe (Optional)

Receiver Commands 145
Receiver Commands
$PASHR,PPS
The response message is output in the format:
$PASHR,PPS,f1,f2,c3*hh
Table 6.40 outlines the parameters.
See the Timing Pulse and Measurement Strobe (Optional) section on page 47 for more information
on the conditions surrounding timing pulse generation, accuracy, and precision.
PRT: Serial Port Baud Rate
$PASHQ,PRT,[c1]
This command queries the baud rate code of the DG16 serial port to which you are
currently connected, where c1 is the optional serial port designator for the output
of the response. If a port is not specified, the receiver sends the response to the
current port. Issue the query command $PASHQ,PAR to see the baud rate codes
for both serial ports.
$PASHR,PRT
The response is output in the format:
$PASHR,PRT,c1,d2*hh
Table 6.40. $PASHR,PPS Message Format
Parameter Description Range
f1 Timing pulse output interval (seconds). Timing
pulse output is disabled when this parameter is set
to zero
0 to 99.95
f2 Timing pulse offset value (milliseconds) -999.9999 to
+999.9999
c3 Synchronization parameter setting for GPS time R(ising edge)
F(alling edge)
*hh Checksum
DEFAULT SETTING
PPS Period 1 second
Offset 0.0000
Synchronization GPS time synchronized to the rising edge of the
pulse