ashtech DG16 - DIR,DEL: Delete Beacon Station from Beacon Directory

320 DG14 and DG16 Board & Sensor Reference Manual
DIR,DEL: Delete Beacon Station from Beacon Directory
$PASHS,BCN,DIR,DEL,f1,[d1]
This command deletes the specified Beacon station from the Beacon directory
where f1 is the frequency, in KHz, and d1 is the Station ID.
If you do not specify a Station ID, then all stations with the frequency specified are
deleted from the Beacon directory.
If you specify both a frequency and Station ID, the frequency must match the
frequency for the specified Station ID, or no Beacon station will be deleted from the
Beacon directory.
If you specify a Station that is locked, then deleting the Station from the Beacon
directory will not remove the Never-Use lock from the station. You must use the
$PASHS,BCN,CLR to remove the Never-Use lock.
DIR,INI: Reset Beacon Directory
$PASHS,BCN,DIR,INI
This command restores the Beacon directory from FLASH to the factory defaults.
MAN: Manual Mode
$PASHS,BCN,MOD,MAN
This command sets the DG16 Beacon functionality to Manual mode. For more
information on the Beacon Manual mode, see Manual Modes, on page 71.
After manual mode is set, both Beacon channels stop operating until the channels
are assigned specific stations/frequencies with the $PASHS,BCN,CHN command
(For more information on the $PASHS,BCN,CHN command, see page CHN:
Assign Beacon Station Channel, on page 317).
MOD: Query Beacon Mode
$PASHQ,BCN,MOD
This command queries the mode that the Beacon functionality is currently in.
$PASHR,BCN,MOD
The response is in the format:
$PASHR,BCN,MOD,s1,s2