318 DG14 and DG16 Board & Sensor Reference Manual
$PASHS,BCN,CHN,d1 OFF
This command disables the specified channel, where d1 is the channel 1 or 2.
Examples
Enter the following command to set Channel 1 to track the Beacon Station at Pigeon
Point, CA
$PASHS,BCN,CHN,1,287,883,100
Enter the following command to disable Channel 1.
$PASHS,BCN,CHN,1,OFF
CLR: Clear Never-Use Mark
$PASHS,BCN,CLR,p1
This command clears the never-use mark for the specified frequency. p1 is the
frequency ranging from 283.5 to 325 KHz.
Example
Enter the following command to clear 287 KHz from the never-use frequency mark
list.
$PASHS,BCN,CLR,287.0
DIR: Beacon Directory
$PASHQ,BCN,DIR
This command queries for the entire current Beacon directory.
$PASHQ,BCN,DIR,DEF
This command queries for the Beacon directory of the stations only in the default list.
$PASHQ,BCN,DIR,RTC
This command queries for the Beacon directory of the stations with only RTCM
message type 7.
d2 Radio Beacon broadcast ID (station ID) 0 to 1023
d3 Bit Rate 25, 50, 100, 200
Table 9.17. $PASHS,BCN,CHN Parameters
Parameter Description Range
To Next Page
Loading...