Receiver Commands 155
Receiver Commands
SES,SET: Individual Session Programing
$PASHS,SES,SET,c1,c2,d3,d4,f5,d6,d7,d8
This command sets the individual sessions for session programming. This
command sets a single session. Up to 10 sessions may be programmed. You must
use this command with the $PASHS,SES,PAR command.
Example
Enter the following command to set a session starting at 0100 that will run for
2 hours.
$PASHS,SES,SET,A,Y,010000,030000,10.0,10,3,0
If sleep mode is enabled, the receiver automatically powers on 2 minutes prior to session time to
ensure all available satellites are tracked by the time recording starts.
$PASHQ,SES,[c1]
This command queries session programming parameters, where c1 is the
optional output serial port.
Example
Enter the following command to query session programming parameters.
$PASHQ,SES
Table 6.49. SES,SET Message Structure
Setting
Parameter
Description Range
c1 Session name A to J
c2 Session flag Y = Yes
N = No
d3 Session start time
(hhmmss)
hh = 0-23
mm = ss = 0-59
d4 Session end time
(hhmmss)
hh = 0-23
mm = ss = 0-59
f5 Session record interval 0.1 to 999
d6 Session Elevation Mask 0 to 90
d7 Session min satellite 1 to 9
d8 Session data type 0, 2, or 4
To Next Page
Loading...