330 DG14 and DG16 Board & Sensor Reference Manual
Warning Window
The Warning window reflects errors and warnings. These messages appear
during the files reading and writing, compiling or uploading of a project, etc. and
informs you about ending of some long-run processes, such as the end of
uploading.
Creating a Custom Message
To create a new message:
1. Open the project.
2. Click in the left pane.
3. Select Add New Message from the Edit menu.
4. Start to fill the field of the Message Parameter pane.
5. Select Save Project from the File menu to save the new message.
You can copy, paste from the clipboard, and delete the selected message by using the
corresponding commands in the Edit menu.
Description Displays a brief description of the selected variable.
Request and Response
Messages format Displays the messages view.
Query Command Displays the query command. If the message header is Ashtech, the
query command format is $PASHQ,NEW, when NEW is the message title.
If the message header is Other, the query command format is NEW,
when NEW is the message title.
Set Command Displays the set command. If the message header is Ashtech, the set
command format is $PASHS,UDM,NEW, when NEW is the message title.
If the message header is Other, the query command format is NEW,
when NEW is the message title.
Request Confirmation
(ACK, NAK)
You can mark the check box to get confirmation.
Save Saves changes.
Cancel Restores the last saved state.
Table A.1 Message Parameter Pane (Continued)
Item Description
To Next Page
Loading...