Differential Commands 315
Differential Commands
Beacon
Directory and
Channel
$PASHS,BCN,CHN,OFF Disable specified channel 318
$PASHS,BCN,CLR Clear the Never-use mark for the
specified frequency
318
$PASHS,BCN,DIR,ADD Add a specified Beacon station to
the directory
316
$PASHS,BCN,DIR,CLR Erase the beacon directory 319
$PASHS,BCN,DIR,DEL Delete the specified frequency and
bit rate entry in the beacon
directory
320
$PASHS,BCN,DIR,INI Restore the Beacon directory from
Flash- return to factory default
320
$PASHQ,BCN,DIR Query the Beacon directory 318
$PASHQ,BCN,DIR,DEF Query the Beacon directory for
stations from the default list
318
$PASHQ,BCN,DIR,RTC Query Beacon directory for RTCM
message Type 7 stations
318
$PASHQ,BCN,DIR,USR Query the Beacon directory for
user entered stations
319
$PASHS,BCN,NVR Mark a frequency to never use in
Automatic mode
321
$PASHQ,BCN,NVR Query the frequencies set to never
use in Automatic mode
321
$PASHS,BCN,RT7 Enable RTCM message type
7overwrite blocking
Y322
Beacon
Memory and
Almanac
$PASHS,BCN,ALM Enable/disable internal almanac
message
317
$PASHQ,BCN,ALM Query for internal almanac
message
317
$PASHS,BCN,RST Reset all Beacon parameters 322
$PASHS,BCN,SAV Save the Beacon parameters 323
Output $PASHS,BCN,OUT Set the serial port for output 322
Table 9.14. Beacon Commands
Function Command Description Default Page
To Next Page
Loading...