Aspen Avionics EFD1000 E5 - 10.4.6.18 Installation Menu Page - MISC CONFIG C; 10.4.6.20 Installation Menu Page - RSM CALIBRATION

EFD1000 E5 Dual Electronic Flight Instrument (EFI) Install Manual
DOCUMENT # 900-00041-001 PAGE 146-226 REVISION D
© Copyright 2019 Aspen Avionics Inc.
10.4.6.18 Installation Menu Page – MISC CONFIG C
COMPOSITE PHASE (VOR1,2) – If the analog NAV receiver has a 180⁰ phase shifted
output (i.e.,RT-385) then select 180 for VOR1.
GPSS GAIN - 1.0 is default, Rate Based autopilots may need a setting of up to 2.0.
CRS SDI – For a dual A429 GPS interface set to NAV 1/2 and set GPS1 for SDI=LNAV1
and GPS2 for SDI=LNAV2. All other GPS configurations set to COMMON. See Figure 9-
27.
INSTALLATION MENU PAGE – MISC CONFIG C
Feature
Options
Actual Setting
COMPOSITE PHASE
(VOR1,2)
(0,0) (180,0)
GPSS GAIN:
0.5 to 2.0 (0.1 increments)
CRS SDI
COMMON, NAV 1/2
OBS DISPLAY
Not applicable
Pitch Sync for
Helicopters
Not applicable
10.4.6.19 Installation Menu Page – MISC CONFIG D
This page not applicable to the EFD1000 E5
10.4.6.20 Installation Menu Page – RSM CALIBRATION
The following menu will be used in the next section to calibrate and validate the
magnetometer in the RSM. Heading errors of up to +/- 6.0º can be calibrated at 30º
increments beginning with North. (Follow RSM Cal procedure in Section 10.5.)
INSTALLATION MENU PAGE – RSM CALIBRATION
Feature
Options
START CALIBRATION
Press to Initiate
ACCEPT CALIBRATION?
Press to ACCEPT Cal
REJECT CALIBRATION?
Press to REJECT Cal
HDG SEL
030º to 360º (in 30º increments)
HDG ADJ
-6.0 to +6.0 (degrees)
Notes: