6. Device installation and start-up
User Manual – PhysioGo.Lite Electro page 26 / 96
6.3.2 Language
Information on the display may be presented in different language versions (depending on the software version).
The user is free to select language options.
To set the language version, press the Language button in the list of setup options, then press the desired version.
The version is changed after the operation is confirmed.
6.3.3 Global settings
6.3.3.1 Date and time
In this section there is a possibility to adjust date and time. To change these settings, press the button Edit. Using
arrows, set the required value. Confirm settings using Set button or leave the edition mode by pressing Cancel.
6.3.3.2 Sounds
The user may configure settings of acoustic signals, which occur during unit operation. Description of available
configuration options:
• Keys sound
• Sound during treatment
• End of treatment sound
• Warning sounds
• Initial sound
• End of treatment sound – see table below
Setting Device reaction
0
No signal
1 – 10 Number of signals
∞ (infinity symbol)
Signal active until disabled by the operator
• Sound tone – type of emitted signal.
In order to set the appropriate option, select or clear the selection field by its pressing. For the "End of treatment
sound" and "Sound tone" parameters, click on the value to change it.
6.3.3.3 Volume
The user may adjust sound volume level. To perform this action:
• press the volume bar at desired place, or
• use buttons on the screen.
6.3.3.4 Display
The user may adjust display brightness level. To perform this action:
• press the value bar at desired place, or
• use buttons on the screen.
6.3.4 Functional settings
6.3.4.1 Channel operation mode selection
This function allows the user to set preferred style of unit operation.
To Next Page
Loading...