Astar PhysioGo.Lite Electro - Transport Position - Trolley for the Unit

6. Device installation and start-up
page 29 / 96 Issue date 18.05.2021, rev. 1.0
Transport position – trolley for the unit
Step Description
1.
Click the UNIT ON / OFF (STANDBY) button on the front panel .
2.
A message will appear on the display:
3.
Press to shut down the system correctly.
4.
Disconnect from the controller the power cord and accessories.
5.
Remove the device and accessories from the trolley.
6.
Then unlock all wheel brakes of the trolley.
7.
Transport the trolley. Move the device and accessories separately.
8.
After arranging the trolley in the destination place, lock the brakes.
9.
Place the device on the upper shelf. Reconnect the switched-mode power supply and the
accessories.