Operation
4812160101_A.pdf2014-07-04
Recommended layer thickness for different material and amplitude settings.Recommended layer thickness for different material and amplitude settings.
In general automatic mode (AUT) and position 10 on the amplitude selector are used. In those
cases where it can be an advantage to reduce the amplitude, the following settings are
recommended for different material and layer thicknesses.
In general automatic mode (AUT) and position 10 on the amplitude selector are used. In those
cases where it can be an advantage to reduce the amplitude, the following settings are
recommended for different material and layer thicknesses.
(A) - Compaction of thin layer(A) - Compaction of thin layer
(B) - Compaction of layer over surface sensitive to vibration(B) - Compaction of layer over surface sensitive to vibration
Amplitude mode table with recommended layer thicknesses (m).Amplitude mode table with recommended layer thicknesses (m).
Mode (A) (B) (A) (B) (A) (B) (A) (B)Mode (A) (B) (A) (B) (A) (B) (A) (B)
CA3500 CA3600 CA5000 CA6000CA3500 CA3600 CA5000 CA6000
11
2 0,1 0,1 0,1 0.1/DCA2 0,1 0,1 0,1 0.1/DCA
3 0,2 0,3 0,2 0,3 0.2/DCA 0,4 0,2 0,53 0,2 0,3 0,2 0,3 0.2/DCA 0,4 0,2 0,5
4 /DCA 0,4 /DCA 0,4 0,6 0,74 /DCA 0,4 /DCA 0,4 0,6 0,7
5 0,3 0,5 0,3 0,5 0,3 0,8 0,3 0,95 0,3 0,5 0,3 0,5 0,3 0,8 0,3 0,9
6 0,6 0,6 1,0 1,16 0,6 0,6 1,0 1,1
7 0,7 0,7 0,4 1,37 0,7 0,7 0,4 1,3
8 0,8 0,8 0,4 1,2 1,58 0,8 0,8 0,4 1,2 1,5
9 0,9 0,99 0,9 0,9
10 0,4 1,0 0,4 1,0 0,5 1,4 0,6 1,810 0,4 1,0 0,4 1,0 0,5 1,4 0,6 1,8
Recommended layer thicknesses for the different amplitude modes for the cases described
above.
Recommended layer thicknesses for the different amplitude modes for the cases described
above.
If the surface is very sensitive to vibration it is recommended to do a test compaction to
determine the optimal amplitude mode.
If the surface is very sensitive to vibration it is recommended to do a test compaction to
determine the optimal amplitude mode.
/DCA is the recommended mode for compaction control and documentation with "Dynapac
Compaction Analyzer" (DCA).
/DCA is the recommended mode for compaction control and documentation with "Dynapac
Compaction Analyzer" (DCA).
69
To Next Page
Loading...
Need help?
General
