Maintenance - 50h
4812160101_A.pdf2014-07-04
Maintenance - 50h
Park the roller on a level surface.
The engine must be switched off and the
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
Park the roller on a level surface.
The engine must be switched off and the
parking brake activated when checking or
adjusting the roller, unless otherwise specified.
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Air cleaner
- Check hoses and connections
Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine.
Check that the hose clamps between the filter
housing and the suction hose are tight and that
the hoses are intact. Inspect the entire hose
system, all the way to the engine.
Replace if necessary, as damage to hoses/hose
clamps can seriously damage the engine
Drum - Oil change
Fig. Left drum side
1. Groove
1
NOTE: This 50 hour oil change only applies to a new
machine, or after renovation of the drum.
Position the roller on a flat surface with the groove (1)
on the inside of the drum aligned with the top of the
drum frame.
111
To Next Page
Loading...