ATTILA
EN
32
8. USE
Before using the equipment, check that it is in perfect condition. In the presence of faults, the equipment
must be decommissioned and the Technical Assistance Service must be contacted.
CAUTION
Keep all the supply and return air ventilation openings inside the equipment free of
obstructions.
When the equipment is in STOP mode, keep the door half-open to avoid stagnation.
8.1. CHECKS BEFORE USE
Only specialised technical personnel should carry out the initial start-up of the equipment.
Before switching on, check that:
▪ The equipment and surrounding surfaces are dry
▪ The equipment is in a perfectly flat and level position
▪ The operating parameters have been adjusted (see chapter “CONTROL PANEL”)
▪ The main switch is in the “0-OFF” position
▪ There is no direct or indirect contact with live electrical parts
Do not perform operations with wet or damp hands.
Clean the equipment and its components thoroughly before loading the product (see chapter “CLEANING”).
To Next Page
Loading...