Attila DIGITAL - Cell Sterilisation Cycle (if Any); Core Probe Heating (if Fitted)

ATTILA
EN
44
8.5.6. CELL STERILISATION CYCLE (IF ANY)
To activate a sterilisation cycle, close the equipment door.
If the door is opened during the sterilisation cycle, the cycle stops.
To sterilise the cell:
STEP ACTION
1
Press the button and select the cell sterilisation function (Parameter StE).
2
Press button to start the cycle.
Note: The LED lights up. The display shows the parameter StE.
3
At the end of the cycle, the buzzer sounds and the equipment automatically switches to the stop status.
Note: the buzzer can be muted with the button.
4
To interrupt the cycle, press the button.
If the conditions are not met, the relevant LED will flash 3 times, indicating that the operation will not be carried out.
8.5.7. CORE PROBE HEATING (IF FITTED)
For heating the core probe:
STEP ACTION
1
Press the button and select the core probe heating function (Parameter Prb).
2
Press the button to start the core probe heating.
Note: The LED lights up. The display shows the parameter Prb.
3
At the end of heating, the buzzer sounds and the equipment automatically switches to the stop status.
Note: the buzzer can be muted with the button.
4
To interrupt the cycle, press the button.
If the conditions are not met, the relevant LED will flash 3 times, indicating that the operation will not be carried out.