Attila DIGITAL - Timed Blasting Cycle

ATTILA
EN
42
8.5.4. TIMED BLASTING CYCLE
To carry out the timed blasting cycle:
STEP ACTION
1
Press and select the time target.
2
Press the button repeatedly to display the cycle duration.
Note: Within 3 seconds use and to change the time.
Note: To reset the blasting cycle target to the default value, press the button three times.
3
Press the button and select positive (+3°C) or negative (-18°C) blasting mode.
Note: The unit of measurement (°C or °F) is shown in the icon at the side of the display.
4
Within 3 seconds, use the buttons and to change the temperature.
Note: To reset the blasting cycle temperature to the default value, press the button three times.
5
Press the button and select Soft or Hard mode.
6
Press button to start the cycle.
Note: The buzzer emits a short sound and the LED lights up. The display shows the time remaining
until the end of the cycle.
7
During the cycle, press and to display:
▪ Time remaining
▪ Elapsed time
▪ Cell temperature.
Note: During the cycle, press the button to display the current target value.
8
The blasting cycle ends when the selected time is reached, the buzzer sounds and the equipment automatically
switches to the storage phase.
Note: the buzzer can be muted with the button.
9
To interrupt the cycle, press the button.
Note: Pressing again restarts the blasting cycle with the default settings.