Attila DIGITAL - Use of ALADINO Version Blast Chiller; Activation; Operating Modes

ATTILA
EN
48
8.6. USE OF 'ALADINO' VERSION BLAST CHILLER
8.6.1. ACTIVATION
Do not start the equipment with wet hands or when there is contact with water.
STEP ACTION PICTURE
1
Press the O/I main switch.
Note: when switched on, the button lights up green.
8.6.2. OPERATING MODES
The equipment is set up with the following programmes:
Positive blasting or cooling Cooling cycle (+3°C)
Negative blasting or freezing Negative blasting cycle (-18°C)
Negative deep-blasting or freezing Negative blasting cycle (-35°C)
Innite negative blasting or freezing Infinite negative blasting cycle (-40°C)
Each programme can be set in the following mode:
• 'AUTOMATIC': temperature-based (requires pin insertion), it is set with a blasting phase and a preservation phase
(automatically switched).
When the set temperature is reached, operation automatically switches to preservation mode; an intermittent sound is emitted
for 3" and the display shows the temperature detected by the pin.
• 'MANUAL': time-based, it is set with a blasting phase and a preservation phase (automatically switched).
The equipment allows the following operating modes to be managed:
• Positive blasting or cooling
• Negative blasting or freezing
• Negative deep-blasting or freezing
• Infinite negative blasting or freezing
• Blasting end with core probe or timed
• Preservation
• Manual defrost