AudioCodes 405 - 4.9 Adjusting Volume

405 and 405HD IP Phone
User's Manual 30 Document #: LTRT-12045
4.9 Adjusting Volume
You can adjust the volume of the phone's

Ring

Tones (e.g., dial tone)

Handset

Speakerphone

Headset
4.9.1 Adjusting Ring Volume
You can adjust the volume of the ring indicating an incoming call.
Note: By default, you can adjust ringing volume in the phone's LCD. Your network
administrator, however, can block this capability and provision ringing volume remotely. If this
was done and you need to adjust the ringing volume, consult your network administrator.
 To adjust ring volume:
1. When the phone is in idle state (i.e., not in use), press the - or + key; the Ringer
Volume bar is displayed on the screen:
2. Press the - or + key on the phone to adjust the volume. After adjusting, the Ringer
Volume level disappears from the screen.
4.9.2 Adjusting Tones Volume
You can adjust the volume of the phone's tones, including dial tone, ring-back tone and all other
call progress tones.
 To adjust tones volume:
1. Off-hook the phone (using handset, speaker or headset).
2. Press the - or + key; the Tones Volume bar displays on the screen:
3. Press the - or + key to adjust the volume. After adjusting, the Tones Volume bar
disappears from the screen.