102
11.4.2 VCI Firmware Upgrade
The V200 support firmware upgrade via either Bluetooth or a USB cable.
11.4.2.1 Update via Bluetooth
Before updating the V200 software, ensure the tablet’s network connection to the Internet
is stable.
➢ To update the MaxiVCI V200 firmware via Bluetooth
1. Connect the V200 to the vehicle or charge it with an adapter before pairing it
with the tablet via Bluetooth.
2. On the MaxiTPMS Job Menu, tap Settings > VCI Manager, and select the
Bluetooth button on the top-left corner of the screen. Pair the tablet with V200
by tapping the device’s serial number on the screen.
3. When the pairing is successful, the connection status displays as connected.
4. Tap Firmware upgrade > Detect Firmware to check if an update for the V200
is available.
11.4.2.2 Update via USB Cable
When the V200 is connected with the tablet using a Type-C to Type-C USB cable, tap
Firmware upgrade > Detect Firmware Version to check if an update is available.
11.5 System Settings
This function provides you with direct access to the System Settings screen, where you
can adjust various system settings for the tablet, including wireless and networks settings,
various device settings such as sound, display, and language settings.
11.6 Printer Manager
The Printer Manager function enables you to switch the way for report printing. There are
two printing methods available:
⚫ Printing via PC Link
⚫ Printing via Wi-Fi
11.7 Report Upload to Cloud
Toggle the ON/OFF button to enable or disable the Report Upload to Cloud function. If
the button displays blue, it indicates the function is enabled. If the button displays gray, it
To Next Page
Loading...
