52
5 TPMS Retrofit
Retrofit is needed to be performed if your vehicle is not installed with TPMS system by
default. Tap on the TPMS Retrofit application button on the MaxiTPMS Job Menu to
access the function.
5.1 Retrofit
This function is used to install TPMS system in vehicles. Tapping the TPMS Retrofit
application icon opens the Vehicle Identification screen. See Vehicle Identification for
additional information.
Prior to use the function, ensure the ignition light is in ON position with the MaxiVCI V200
device successfully connected to the vehicle and the tablet.
➢ To perform retrofit function
1. Tap the TPMS Retrofit application button from the MaxiTPMS Job Menu.
2. Select the manufacturer button of the test vehicle, followed by the vehicle model
and year.
3. Tap OK at the bottom of the screen to confirm information of the tested vehicle.
The Retrofit screen opens.
4. Simply follow the operation instructions displayed on the screen, which will
guide you to choose the corresponding buttons during each procedure,
including the Back-up, Retrofit, and Restore buttons.
The Retrofit function screen has the same lay out with that of the TPMS screen. After the
retrofit function is finished, tap on the other tabs to perform optional functions.
To Next Page
Loading...
