97
Before performing this function, make sure the vehicle's ignition key is in the
ON (RUN) position with the engine off.
➢ To erase codes
1. Tap Erase Codes from the Function Menu.
2. A warning message displays to advice of data loss if this function is
completed.
a) Tap Yes to continue. A confirming screen displays when the
operation is successfully done.
b) Tap No to go back to the Function menu.
3. Tap ESC on the function menu to exit Erase Codes.
4. Perform the Read Codes function again to check if the code have
been erased successfully.
8.4.2.4 Live Data
When this function is selected, the screen displays the data list for the
selected module. The items available for any control module vary depending
on vehicle. The parameters display in the order that they are transmitted by
the ECM, so expect variation between vehicles.
Gesture scrolling allows for quick movement through data list. Using one or
two fingers, simply swipe the screen up or down to locate the data you want.
The figure below shows a typical Live Data screen:
To Next Page
Loading...
