Autronica AutroGuard Multicriteria Protector V-430 Series - Document Revision Log

Introduction
AutroGuard Multicriteria Protector Series V-430, V-530, V-100, V110 and V-120,
AutroGuard-Technical-Handbook, Doc-1004339-4, 2022-12-09,
Autronica Fire and Security AS
Page 4
1.7 Document Revision Log
Revision
Date
Description/Corrections
Revision 1
2020-06-29
Officially approved by Autronica Fire and Security AS
Revision 2
2021-05-17
• Added part numbers for Air Duct Samling Units and Removal tool
• Added new ch. 10 “Preparing for Configuration”
• Some changes/added information in technical specifications ch. 4
(system compatibility)
• Added new ch. 2.6 “Recommendations for latest available
Firmware and Operating System”
• Changed ordering information ch. 3.3
• Changes in configuration, ch. 11
Revision 3
2021-08-08
• Added new ch. 12 for the configuration of Autroprime systems.
• Correction, requirement: AutroSafe Configuration Tool, version
4.11 or higher.
• Added and corrected technical specifications in ch. 4.1
• Added new ch. 11: “Configuration Recommendations”
• Corrections: ch. 4.5: Integrated VAD – Current Consumption
• Added new ch. 4.6: Integrated VAD and Sounder – Current
Consumption
• Added new ch. 14.6: “Calibrating the Cover Detection Sensor”
• Added new ch. 16.1: “UL Regulatory Information”
• Added UL specific information to “Technical Specifications”
according to UL requirements, ch. 4.1
• Ordering information, added UL variant in matrix, ch. 3.2.1 and
3.2.2.
• Removed previous ch. 3.2 “Series and Variants”
• Revised ch. 3.3 “Labeling” (incl. all subchapters)
• Corrections: Ch. 8.4 “Current Consumption on Detection Loop”,
Alarm and Fault
• Ordering information AutroGuard Retro Variants, ch. 3.2.6
• Added text to ch. 14.3.3 “Automatic Test Mode”
• Added textt to ch. 3.1
• Part number 116-WBJ-220 and new picture added to ch. 15.8.
• Added rated operating voltage for protector UL variant to
technical specifications in ch. 4.1