Configuration for Autroprime
AutroGuard Multicriteria Protector Series V-430, V-530, V-100, V110 and V-120,
AutroGuard-Technical-Handbook, Doc-1004339-4, 2022-12-09,
Autronica Fire and Security AS
Page 97
13. Configuration for Autroprime
13.1 Introduction
This chapter provides information specifically intended for the
configuration of the AutroGuard® Multicriteria Protector only.
For further information on system configuration, refer to the
configuration handbook for Autroprime.
System configuration must be done by trained/certified technical
personnel who are familiar with the system and national/local
regulations.
Note that one protector occupies one address only, regardless of the
number of add-ons (sounder, visual alarm devices, etc.).
13.2 Autroprime Software Requirements
The use of AutroGuard protectors requires Autroprime version 2.2.0
or later (not yet implemented).
To Next Page
Loading...
