Configuration for AutroSafe
AutroGuard Multicriteria Protector Series V-430, V-530, V-100, V110 and V-120,
AutroGuard-Technical-Handbook, Doc-1004339-4, 2022-12-09,
Autronica Fire and Security AS
Page 80
12. Configuration for AutroSafe
12.1 Introduction
This chapter provides information specifically intended for the
configuration of the AutroGuard® Multicriteria Protector only.
The following configuration chapters contain references (where
necessary) to the chapters in this handbook where the functionality is
described in detail.
For further information on system configuration, refer to the
configuration handbook for AutroSafe.
System configuration must be done by trained/certified technical
personnel who are familiar with the system and national/local
regulations.
Note that one protector occupies one address only, regardless of the
number of add-ons (sounder, visual alarm devices, etc.).
12.2 AutroSafe Configuration Tool Requirements
The configuration requires the use of AutroSafe Configuration Tool,
version 4.11 or higher.
To Next Page
Loading...
