Avaya S8700 - Page 8

8
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Contents
May 2003
Connect DC Power Distribution Unit Ground 105
Connect DC Power Cabinet Ground 106
Making DC Power Connections 107
DC Power Connections with DC Distribution Unit 108
Stacking DC Power Cabinets 108
Connect AC Power to DC Power Cabinet 111
Connect Battery Cabinet 112
Connect Optional Battery Leads 112
Ground and Connect AC-Powered Media Gateways 113
Connect AC-Power Ground 114
Set the Ringer Frequency 115
Connect the Power Cord into the Power Receptacle 116
Connect Time Division Multiplexing Bus Cables 116
Verify Port Media Gateway Address Plugs 118
Install Rear Panels 119
Install Rear Ground Plates (Media Gateways
with Earthquake Protection) 119
Install Front Ground Plates (Media Gateways with
Radiation Shielding and Earthquake Protection) 121
Install Media Gateway Clips (Media Gateways
without Earthquake Protection) 123
Connect Media Gateway Cables 124
Installing the Avaya G700 Media Gateway 125
• Install Main Distribution Frame 127
Space Requirements and Layout 128
Installation Space Requirements 128
Layout 129
Install Main Distribution Frame Hardware 131
MDF Cross-Connect Fields 134
Placing the Main Distribution Frame 134
Main Distribution Frame Labels 136
Mount 110A- or 110P-type terminal blocks on the wall 137
Mount 110P-type terminal blocks on a frame 139
Install Cable Slack Managers 141
• Connect the Media Gateway to the MDF 144
Equipment Room Cabling Labels 144
Cable Routing Guidelines 145
Control Carrier Outputs Cable Installation 145
Trunk Cables Among Network Interface,
Sneak Fuse Panel, and Media Gateway 146