Avaya S8700 - Page 9

9
Installing the Avaya™ S8700 Media Server with Avaya™ MCC1 or SCC1 Media Gateway
Contents
May 2003
Install Cables Between Media Gateway and MDF 148
Install Connector Cables Between Auxiliary
Cabinet (if used) and MDF 149
• Connect the MDF to Stations and PSTN 150
Station (Telephone) Wiring Design 150
Information Outlets 150
Station Cables 150
Closets 152
Satellite Locations 152
Site Locations 153
Station Circuit Distribution from Equipment Room 153
4-Pair Station Circuits 154
3-Pair to 4-Pair Station Circuit Distribution 154
Connected cable station adapters 158
Complete Provisioning Plan 161
Install Sneak Current and Off Premise Protection 163
Install Sneak Fuse Panels 166
Install the Coupled Bonding Conductor 167
Install Coupled Bonding Conductor Wires 167
Install Coupled Bonding Conductor 168
Install and Administer the Patch Cord/Jumper 170
Label Expansion Control Carrier Cable (MCC1 only) 172
Connect Expansion Control Carrier Outputs
Cable (MCC1 only) 173
Connect Trunk Pairs Using Concentrator Cables 173
Connect Trunk Pairs to Media Gateway Using
Jumper Wires To Establish 3-Pair Modularity 174
• Installing the Stratum 3 clock (if used) 177
Unpack and Inspect Stratum 3 Clock Cabinet 177
Install and Position Stratum 3 Clock Cabinet 177
Connect AC Power to Stratum 3 Clock Cabinet 178
Check and Connect Commercial AC Power 178
Connect DC Power and Ground to Stratum 3 Clock Cabinet 178
Connect Clock Cabinet Grounding 178
Connect Stratum 3 Clock DC Power 178
Set the Clock Options 179
Cable the Stratum 3 Clock 180
Install the Stratum 3 Clock Wiring 182