Avaya Vantage - Page 110

Parameter Type Default
value
Is set to
default
on reset
Description
For provisioning, use:
• A name=value pair in a DHCPACK message.
• The SET command in the 46xxsettings.txt
file.
• The Settings > Network > Ethernet > VLAN >
VLAN test timer menu on the device.
PHY2TAGS Numeric 0 Controls whether VLAN tags are stripped from
frames forwarded to the secondary Ethernet
interface.
Assign one of the following values:
• 0: VLAN tags are removed from frames forwarded
to the secondary Ethernet interface.
1: VLAN tags are not removed from frames
forwarded to the secondary Ethernet interface.
For provisioning, use the SET command in the
46xxsettings.txt file.
PHY2VLAN Numeric 0 Specifies the value of the 802.1Q VLAN identifier
that is used to identify tagged frames through the
secondary Ethernet interface.
Valid values are 0 through 4094.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file. The precedence is 3.
• LLDP. The precedence is 4.
VLANSEP Numeric 1 Specifies whether the VLAN separation is enabled
or disabled.
Assign one of the following values:
• 0: Disabled.
• 1: Enabled.
For provisioning, use the SET command in the
46xxsettings.txt file.
Supported configuration parameters
May 2018 Installing and Administering Avaya Vantage
™
110
Comments on this document? infodev@avaya.com