The number must be in a range between 128 to 254.
Additional network configuration
Setting the Ethernet interface control
Procedure
1. Open the Settings menu.
2. Tap Network > Ethernet.
3. Tap Interfaces.
4. (Optional) If the interface options are disabled, enable the administrator mode.
5. To view the Ethernet mode, tap Ethernet.
The Ethernet mode is set to auto negotiation and cannot be modified.
6. To configure the secondary Ethernet interface, tap PC Ethernet and select one of the
following:
• Disabled: To disable the PC Ethernet interface.
• Auto: To enable and configure the PC Ethernet mode to auto negotiation.
Setting the 802.1x authentication mode
Procedure
1. Open the Settings menu.
2. Tap Network > Ethernet.
3. Tap IEEE 802.1x authentication.
You might need to enter the administrator password.
4. (Optional) To change the setting for the Pass through mode, tap Pass through mode,
and select one of the following options:
• On: To enable multicast pass-through without proxy logoff.
• Multicast pass through and proxy logoff: To enable multicast pass-through with proxy
logoff.
• Off: To disable multicast pass-through.
5. (Optional) To change the setting for the Supplicant mode, tap Supplicant mode, and
select one of the following options:
• Off: To disable the Supplicant operation.
• On, unicast EAPOL only: To enable the Supplicant operation. The device responds
only to received unicast Extensible Authentication Protocol over LAN (EAPOL)
messages.
Device configuration using the Settings menu on the device
May 2018 Installing and Administering Avaya Vantage
™
63
Comments on this document? infodev@avaya.com
To Next Page
Loading...
