Avaya Vantage - Phone Lock Parameters

Parameter Type Default
value
Is set to
default
on reset
Description
menu. If PROCPSWD has the default value, you
cannot access administrator menu options.
This parameter is supported in all modes.
For provisioning, use the SET command in the
46xxsettings.txt file.
This parameter is supported in the Tablet mode.
ALLOW_LOGOUT
_WHEN_LOCKED
Numeric 1 Yes Specifies whether users can log out from the Lock
screen. Assign one of the following values:
• 0: Users cannot perform logout when the device is
locked.
• 1: User can perform logout from the Lock screen.
• 2: Only administrators can perform logout
procedure. Logout procedure is performed using
the Settings application. Only administrators can
force user logout when a user is logged in to the
device and the device is not locked. The logout
option shall not be presented for administrator
when the device is logout.
For provisioning, use
• The SET command in the 46xxsettings.txt
file.
• The settings file received from AADS.
Phone lock parameters
Parameter
Type Default
value
Is set to
default
on reset
Description
ENABLE_PHONE_
LOCK
Numeric 0 No Specifies whether the Lock screen is enabled on
the device.
• 0: The Lock screen is disabled.
• 1: The Lock screen is enabled.
This parameter is not supported in the non Avaya
Breeze
™
CSDK application based mode.
Table continues…
Other operational parameters and settings
May 2018 Installing and Administering Avaya Vantage
™
143
Comments on this document? infodev@avaya.com