Avaya Vantage - IEEE 802.1 X Settings

IEEE 802.1X settings
Parameter Type Default
value
Is set to
default
on reset
Description
DOT1X Numeric 0 Yes Specifies whether the IEEE 802.1X Pass through
operating mode is enabled on Avaya Vantage
™
.
Pass through is the forwarding of Extensible
Authentication Protocol over LAN (EAPOL) frames
between the device’s Ethernet line interface and its
secondary (PC) Ethernet interface.
The options are:
• 0: EAPOL multicast pass-through is enabled
without proxy logoff.
• 1: EAPOL multicast pass-through is enabled with
proxy logoff.
• 2: EAPOL multicast pass-through is disabled.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file.
• The Settings > Network > Ethernet > IEEE
802.1x authentication > Pass through mode
menu on the device.
DOT1XSTAT Numeric 0 Yes Specifies whether the IEEE 802.1X supplicant
operating mode for Ethernet is enabled on Avaya
Vantage
™
. The options are:
• 0: Supplicant operation is disabled.
• 1: Supplicant operation is enabled. Avaya
Vantage
™
responds only to received unicast
Extensible Authentication Protocol over LAN
(EAPOL) messages.
• 2: Supplicant operation is enabled. Avaya
Vantage
™
responds to received unicast and
multicast EAPOL messages.
This parameter is supported in all modes.
For provisioning, use:
• The SET command in the 46xxsettings.txt
file.
Table continues…
Network settings
May 2018 Installing and Administering Avaya Vantage
™
111
Comments on this document? infodev@avaya.com