Server addresses and ports
Parameter Type Default
value
Is set to
default
on reset
Description
DES_STAT Numeric 2 Specifies whether to attempt Avaya Device
Enrollment Service discovery if there is no
configuration file server provisioned on the device.
Discovery is attempted when the device is starting.
You can assign one of the following values:
• 0: Avaya Device Enrollment Service discovery is
disabled and can only be enabled by resetting the
device to its default settings.
• 1: Avaya Device Enrollment Service discovery is
disabled and can be enabled by changing the
value of DES_STAT to 2.
• 2: Avaya Device Enrollment Service discovery is
enabled.
When DES_STAT is set to 2 and
FILE_SERVER_URL is not retrieved from DHCP or
LLDP, the device attempts to communicate with
Avaya Device Enrollment Service during startup to
obtain the provisioning or file server address.
For provisioning, use:
• DHCP option 242. The precedence is 3.
• The SET command in the 46xxsettings.txt
file. The precedence is 5.
DNSSRVR
String 0.0.0.0 Yes Specifies up to three IP addresses of DNS servers
in dot-decimal format.
The value of the parameter is a list of IP addresses
separated by commas without any spaces between
entries. Avaya Vantage
™
tries to connect to DNS
servers in the order specified in the parameter.
Both the Wi-Fi and Ethernet interfaces use the
configured DNS server and domain information. An
option to configure DNS information specifically for
each Wi-Fi network is unavailable. Therefore, if a
user toggles between the Wi-Fi and Ethernet
interfaces, then the configured DNS information is
applicable for both interfaces.
This parameter is supported in all modes.
Table continues…
Network settings
May 2018 Installing and Administering Avaya Vantage
™
113
Comments on this document? infodev@avaya.com
To Next Page
