Avaya Vantage - Upgrade Related Parameters

Upgrade related parameters
Upgrade related parameters
Parameter Type Default
value
Is set to
default
on reset
Description
UPGRADE_POLLI
NG_PERIOD
Integer 60 Yes Specifies the polling interval between two
consecutive attempt of polling both firmware image
and settings file. The polling interval is measured in
minutes. Assign one of the following values:
• 0: Disabled
• 1-10080: Enabled
This parameter is supported by Avaya Vantage
™
with the range of 0 to 65535.
This parameter has no effect on any upgrade
command that is triggered by the management
application or UI.
UPGRADE_POLLING_PERIOD is not affected by
UPGRADE_DLOAD_START and
UPGRADE_DLOAD_END parameters.
This parameter is supported in all modes.
For provisioning, use the SET command in the
46xxsettings.txt file.
UPGRADE_DLOA
D_START
String 00 Yes Specifies a time when Avaya Vantage
™
starts to
download upgrade image files.
The value of parameter is a string in the [Ddd]hh
format, where:
• [Ddd] is a day of the week. The valid values are
Sun, Mon, Tue, Wed, Thu, Fri, or Sat. This
component is optional. If the component is
omitted, Avaya Vantage
™
performs polling every
day.
• hh is one or two numeric digits representing a
hour of the day. The range is from 0 to 23.
If the value of UPGRADE_DLOAD_START is equal
to the value of UPGRADE_DLOAD_END, then no
polling period is specified and Avaya Vantage
™
can
download upgrade files at any time.
UPGRADE_DLOAD_START is ignored if
UPGRADE_POLICY is set to 0.
Table continues…
Supported configuration parameters
May 2018 Installing and Administering Avaya Vantage
™
138
Comments on this document? infodev@avaya.com