Avaya Vantage - Phone UI related settings

Parameter Type Default
value
Is set to
default
on reset
Description
CURRENT_LOGO String Null Specifies whether a custom logo or wallpaper is
currently selected for display.
When the value is null, the built-in default logo or
wallpaper is displayed.
To use a custom logo or wallpaper, the resource
information must be defined in the LOGOS
parameter. You can set the value of
CURRENT_LOGO as the display name of one of
the logos that are defined in LOGOS.
For provisioning, use the SET command in the
46xxsettings.txt file.
For example:
If LOGOS is defined as “Red
Balloon=redballoon.jpg,Blue
Balloon=blueballoon.jpg”, then you can set
CURRENT_LOGO as one of the following:
•
SET CURRENT_LOGO “Red Balloon”
•
SET CURRENT_LOGO “Blue Balloon”
Phone UI related settings
Common operations
Parameter
Type Default
value
Is set to
default
on reset
Description
HEADSETBIDIR Numeric 0 Yes Specifies whether bidirectional signaling is
supported on the headset interface. Bidirectional
signalling allows you to forward off-hook events and
incoming call alerts from Avaya Vantage
™
to a
headset when a headset base station is connected
to the headset connector.
Assign one of the following values:
• 0: Disabled.
• 1: Switch hook and alert signaling are both
enabled.
• 2: Only switch hook signaling is enabled.
Table continues…
Supported configuration parameters
May 2018 Installing and Administering Avaya Vantage
™
92
Comments on this document? infodev@avaya.com