LLDP field Value
• 16 if the Ethernet line interface is operating at
100Mbps, full-duplex
• 29 if the Ethernet line interface is operating at
1000Mbps, half-duplex
• 30 if the Ethernet line interface is operating at
1000Mbps, full-duplex
MANUFACTURER Avaya
POE_USED 1
POE_TYPICAL Typical PoE power usage of the device with
enabled backlight. The parameter is measured in
watts.
POE_MAX Maximum PoE power usage of the device with
enabled backlight. The parameter is measured in
watts. Avaya Vantage
™
uses 13 for this parameter.
TLV impact on system parameter values
Avaya Vantage
™
uses data transmitted in LLDP Type-Length-Value (TLV) elements to set
configuration parameters. If a received LLDP frame contains a TIA LLDP-MED Capabilities TLV,
then Avaya Vantage
™
processes other TLVs in the frame only if the TIA LLDP-MED Capabilities
TLV contains a Device Type of 0 or 4. TLVs are processed in the order that they are received.
System parameter
name
TLV name Impact
L2QVLAN and L2Q IEEE 802.1 VLAN
Name
L2Q is set to 1 (ON).
L2QVLAN is set to the VLAN ID contained in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
VLAN Name TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The current value of L2QVLAN was set by a TIA LLDP MED
Network Policy TLV.
• The VLAN name in the TLV does not contain the substring
“voice” in lower-case, upper-case or mixed-case ASCII
characters anywhere in the VLAN name.
L2Q, L2QVLAN TIA LLDP MED
Network Policy
(Voice) TLV
L2Q is set to 2 (OFF) if the Tagged Flag T is set to 0
L2Q is set to 1 (ON) if the Tagged Flag T is set to 1.
Table continues…
Device configuration using LLDP
May 2018 Installing and Administering Avaya Vantage
™
55
Comments on this document? infodev@avaya.com
To Next Page
Loading...
