Pushing applications onto the Avaya Vantage
™
device
About this task
Use this procedure to push applications to Avaya Vantage
™
without any intervention of the end
user.
Important:
While setting the PUSH_APPLICATION parameter, you must specify each application only
once. If you specify an application more than once, Avaya Vantage
™
might not work as
expected.
Before you begin
Ensure that you have uploaded the application package file on a HTTP or HTTPS server or a
network endpoint.
Procedure
1. Open the 46xxsettings.txt settings file in a text editor.
2. If the settings file contains the string SET PUSH_APPLICATION <a list of URLs>, do
one of the following:
• If the list of URLs contains a URL where the previous version of the application package
file is located, replace this URL with the URL where the latest version of the application
package file is located.
• If the list of URLs contains at least one entry, enter a comma after the last entry, followed
by the URL where the new application package file is located.
Note:
If the application package file is stored in the root directory of the HTTP or HTTPS
server, you can provide the file name only. If the application package file is stored in a
subdirectory of your HTTP or HTTPS server, you must provide a relative path to the
file. If the application package file is stored on a network endpoint, you must provide
the full path to the package file.
3. If the settings file does not contain the string SET PUSH_APPLICATION <a list of
URLs>, do the following:
a. Add a new string with the text SET PUSH_APPLICATION followed by a space.
b. Enter the URL where the application package file is located.
4. Save the settings file.
5. Upload the settings file on the file server.
Result
On the next polling period, Avaya Vantage
™
downloads the settings file and the application
package and installs the application on the device.
Application setup
May 2018 Installing and Administering Avaya Vantage
™
66
Comments on this document? infodev@avaya.com
To Next Page
Loading...
